Housing: High temperature, compression molded, fiberglass impregnated, 3/16" min. wall composite. Charcoal gray. No top lip to trap dirt and moisture. Molded-in solid brass knurled inserts to receive socket base screws. Separate ballast and splice compartments, individual cast aluminum internal covers, with silicone gaskets. Two 3/4" NPT in bottom, 24 cu. in. splice area. Modular reverse draft design (top dia. smaller than bottom), body and ballast modules epoxy bonded.
Lens: Thermally tempered soda lime glass sealed with silicone gaskets.
Gasketing: One-piece molded silicone, U-channel wraps completely around lens flange.
Socket: H.I.D. and incandescent are 4KV medium base. Fluorescent is GX24q-3 (For 26 or 32 watt triple tube lamp).
Wiring: Anti-siphon barriers on all wiring to and from ballast compartment. All components wire linked for ground. Quick disconnect provided for removal of lamp bracket.
Ballast: The H.I.D. ballast is High Power Factor -20° F starting. The fluorescent ballast is electronic with multi-voltage (108V to 305V) input, 50/60 HZ, .98 Power Factor (-0° F). Will operate 26 or 32 watt lamp. Electrical components factory mounted to gasketed compartment cover.
Finish: Super TGIC thermoset polyester powder coat paint, 2.5 mil nominal thickness, applied over an anodized pre-treatment and Titanated Zirconium conversion coating; 2500 hour salt spray test endurance rating. Standard colors are: Black (BL), Dark Bronze (DB), and Verde Green (GR).
Top Cap: Die-cast, low copper (<0.6% Cu) aluminum secured by four concealed and captive stainless steel screws.
Supports: Die-cast, low copper (<0.6% Cu) aluminum secured in place as a complete cage assembly. The top section provides a cutoff lamp compartment. The supports are secured to the socket base by four stainless steel tie rods.
Socket Base: One-piece cast aluminum with eight captive 5/16" blackened stainless steel hex-socket cap screws.
NOTE: